2018 Haybuster H-1130 Big Bite

The H-1130 Big Bite tub grinder is Haybusters heavy-duty PTO grinder. It is designed with the features and the durability you need in a 11 tub grinder. Some of these features include tub tilt, heavy hammermill with plates and hammers along with 1 rods, dual augers and a 26 long stacking conveyor. The 315 hp drive system consists of an 8-groove belt/pulley system powered through a 77 series PTO driveline. The belt system tension is set at the factory and is designed to maintain its desired tension when stretching.

Features may include:

• The dual 12 belly augers are suspended by two heavy-duty bearings and are located at the base of the newly-designed screen area. The auger system allows for a sealed under-screen discharge area. The larger discharge area also provides for higher capacities and reduces the potential for plugging.

• The Big Bite 50 heavy-duty hammermill is now standard equipment and is located at the rear of the tub to reduce the length of the discharge. This, along with the increased area around and under the screens accelerates product discharge and reduces the potential of plugging. The heavy-duty hammermill operates at 2140 rpm and is constructed with 88 swinging hammers. The hammers are hardened and are held in place with 1 case-hardened hammer rods. The hammermill is mounted on a 3 stressproof shaft supported by 3 bearings.

• The large H-1130 Big Bite Tub is constructed of a 10-gauge steel floor and a 12-gauge steel side wall. The width of the tub is 11 3, is 50 deep and can handle the largest round and square bales.