2025 Quicke Powergrab M+ 200

Powergrab M+ 200 Bolt on Hooks prepared
Robust bucket grab designed for silage handling with front loaders, compact wheel loaders and smaller telehandlers.

Bucket grab for Silage handling.
For use with 2 - 3,5 tons lift capacity material handlers.
Compatible with many Z-link compact loaders.

Powergrab M+ is a powerful bucket grab designed for material handlers with a lift capacity of 2 – 3,5 tons.

Powergrab M+ is designed for extraction of clamp silage for farms with high intensive feeding.

The silage grab excels in handling maize silage but also grass silage can be extracted.

The design of Powergrab M+ offers several improvements compared to the popular predecessor such as;

Grab head has four anchor points for increased stability.

Center take-out in grab head to create clearance when using loaders with Z-link kinematics.

Bolted M16 L hooks creates a tight fit between implement and handler.

Grab head is maneuvered by large cylinders with sufficient force for silage removal and extra bars on top of the grab head will help to hold down the material to avoid spillage.

The bucket gable and grab head side tines are also designed to efficiently prevent spillage through the sides. Also, the bucket body has an integrated spill guard on the top preventing spillage backwards - all in all a high efficient silage bucket where grabbed material is properly held in place.

Width 240 and 260 is available with dual grab head, this means that left-hand and right-hand side of the grab head can move independently from each other. This feature is favorable when handling irregular sized blocks of silage as when taking the final chunk out of the silage stock, on top of that is also provides maximum clearance for Z-link loaders.

Grab Bucket is filled by angle the implement downwards at about 45 degrees into the silage. This gives the maximum fill possible when the grab head is later closed.

The design of the tines in the grab head and in combination with rotating the implement downwards, creates an even block of silage without creating any air pockets and generating heat in the silage.

The cutting edge extrudes minimal at each side and the grab head can open considerably leaving the tip of the tines behind the cutting edge, these two features minimizes material left close to walls both in front and at the sides.

Powergrab M+ is available with Bolt on Hook system M16 L that makes it possible to attach it to all most common AG material handlers in this size segment.

An optional bolt on cutting edge is also available that will minimize wear on the Implement.